// Guides // FeNau

Fixing gratings: getting clips, locks and supports right

A grating that is not secured creeps, rattles, tips – or gets taken away. DGUV Information 208-007 therefore requires every grating to be secured against lifting and slipping. What that means in practice and which part goes where.

1. What is required

The German accident insurance guidance DGUV Information 208-007 (“Gratings – selection and operation”) requires gratings to be laid and fixed so that they cannot slip, tip or lift – not even when someone steps on the edge or a neighbouring grating is lifted. Each grating therefore needs at least two fixing points, and four for trafficable gratings, stair treads and anything in public traffic. In addition: DIN EN ISO 14122-2 for platforms (secure gratings against unintentional release), ASR A1.8 for traffic routes, and for buildings the owner's duty of care.

2. Supports and frames

  • Support width: at least 30 mm per side in the bearing bar direction (the two bearing bar ends carry the load); no support is needed on the cross bar sides, but it does no harm.
  • Level and full-surface: a grating that stands on two corners rocks – fatigue failure at the welds, noise, zinc wear. Compensate for unevenness (mortar, shims, grating supports).
  • Frames: angle frames of galvanised steel or stainless steel, height = bearing bar height, cast in concrete with anchors or bolted on; always anchored for trafficable use. Made to measure in the configurator, standard at FeNau frames & surrounds.
  • Steel substructures (walkways, terraces, platforms): support on angle or T sections, gratings clipped directly to the section.
  • Spacers / joints: 3–5 mm between gratings, 5–10 mm at walls; against grating-to-grating rattle, use spacers or rubber pads.

3. Clips and locks – which part goes where

PartFunctionForAt FeNau
Grating clip (single clip)clamps the grating from above to the support section or frame; top and bottom part with screwStandard fixing; to match the pitch (33/33, 33/11, 34/38 …) and bearing bar heightGrating clips
Double clipconnects two adjacent gratings to each other and to the supportRows of grating panels, trafficable areas, walkwaysDouble clips
Grating lock / safety chainconnects the grating to the frame or well; grating can be lifted but not removedLight wells (burglary, theft), public areasLocks & spare parts
Lockable clip / fixing from belowcan only be released with a tool or from the basementLight wells at risk of burglaryon request
Tread brackets / tread boltsbolting the tread to the stair stringerGrating stair treadsTread accessories
Grating support pad (rubber/plastic)Height adjustment, impact noise, separation of stainless steel and zincTerraces, swimming pools, residential areasGrating supports

The clip must match the mesh pitch and the bearing bar height: a 33/33 clip will not engage in a 33/11 mesh. In the configurator, matching clips can be ordered directly with the grating; for gratings from other suppliers, measure the pitch and bearing bar height.

4. How many clips?

SituationMinimum number per gratingPosition
Pedestrian, private, grating in a frame with a stop all round2diagonally opposite, at the bearing bar ends
Pedestrian, walkway / platform / public4all four corners
Trafficable, channel grating, driveway4 (or bolted)corners; additionally in the middle for lengths > 1000 mm
Rows of several gratings2 + double clipsdouble clip at every joint
Grating stair treads4 bolts2 per end bracket
Light well with burglary protection2 lockson the house wall side, accessible from inside

5. Special cases

  • Stainless steel grating on a galvanised frame (or vice versa): separate with EPDM tape or a plastic pad under constant wet conditions (galvanic corrosion); clips in stainless steel.
  • Timber substructure (terrace, jetty): clips with wood screws or bolt the grating into stainless steel angles; protect the timber under the support with EPDM (jetty gratings).
  • Raised floor / data centre: secure gratings against lifting during pallet truck rollout, earthing via clip or earthing strap (more).
  • Swimming pool: clip fixing without protruding screws, impact noise pads, 316 (barefoot grating).
  • Retrofitting existing gratings: safety chain with a wall plug in the well – fitted in 10 minutes, no replacement needed.

Questions and answers

Do I have to fix a grating?

Yes. DGUV Information 208-007 requires every grating to be secured against slipping, tipping and lifting – at least 2 fixing points, and 4 for trafficable and public areas and stair treads.

Which clip fits my grating?

The clip must match the mesh pitch (33/33, 33/11, 34/38 …) and the bearing bar height. The configurator offers matching clips with the grating; for gratings from other suppliers, measure the pitch and height.

How wide does the support need to be?

At least 30 mm per side in the bearing bar direction, level and full-surface – a grating must not rock on two corners.

How do I secure a light well grating against theft or burglary?

With a grating lock (safety chain) or lockable clips; the grating can still be lifted for cleaning but cannot be removed from outside.

What is a double clip?

A clip that connects two adjacent gratings at the joint to each other and to the support – for rows of gratings on walkways and trafficable areas.