// Guides // FeNau

Barefoot grating: closely set U-profiles, hot-dip galvanised

The barefoot grating is a hot-dip galvanised steel grating in which closely set U-profiles close the area between the bearing bars. Here is how it is built, where it is used and what to watch for when installing it.

1. Design

  • Flat steel bearing bars, for example 25/2 mm on the standard size 250 × 1000 × 25 mm.
  • Infill of closely set U-profiles instead of single cross bars.
  • Side banding in flat bar.
  • Steel S235JR, hot-dip galvanised to DIN EN ISO 1461.
  • The first dimension (length) runs in the bearing bar direction, the second (width) in the direction of the U-profiles.

2. Galvanised only

Barefoot gratings are available in hot-dip galvanised steel only – not in stainless steel 304 or 316. If you need a fine-mesh stainless steel area, plan a made-to-measure grating in 304 or 316 with mesh 30/10 in the configurator.

3. Typical uses

  • House perimeters and gravel strips
  • Terraces
  • Jetties
  • Pool surrounds
  • Drainage channel covers

4. Load

According to its data sheet, the standard barefoot grating 250 × 1000 × 25 mm with bearing bar 25/2 mm is rated for a point load of 2.43 kN (approx. 243 kg). It is a pedestrian grating and not suitable for vehicles. As with every grating: bearing bars from support to support, with sufficient support on each side.

5. Important note on "barefoot"

"Barefoot grating" is a model name for a grating with closely set U-profiles and not a guarantee that it can be walked on barefoot. Walking on it barefoot is at your own risk. Hot-dip galvanising can leave zinc drips, spikes or burrs. Check the edges before installation and deburr them if necessary.

6. Installation

  • Check edges and surface before installation, remove zinc drips and burrs.
  • Mind the bearing bar direction: from support to support.
  • Secure the grating with clamps against shifting and lifting.
  • Touch up bare spots after deburring with zinc spray.

7. Sizes

The standard size 250 × 1000 × 25 mm is stocked in our pick-up warehouse in Langenzenn and can be ordered at fenau.eu. Other sizes are made as custom gratings on request – send a sketch and dimensions to gitterroste@fenau.eu.

Questions and answers

Are barefoot gratings available in stainless steel?

No. Barefoot gratings are only made of S235JR steel, hot-dip galvanised. For stainless steel, plan a made-to-measure grating in 304 or 316 with mesh 30/10.

Can a barefoot grating be walked on barefoot?

"Barefoot grating" is a model name and not a guarantee that it can be walked on barefoot. Doing so is at your own risk; galvanising can leave sharp spots that must be deburred before installation.

What is a barefoot grating used for?

Typically at house perimeters, gravel strips, terraces, jetties, pool surrounds and as drainage channel covers.

How much does a barefoot grating carry?

The standard grating 250 × 1000 × 25 mm with bearing bar 25/2 mm is rated for a 2.43 kN point load (approx. 243 kg) according to its data sheet. It is for pedestrians, not vehicles.

Are custom sizes available?

Yes, as custom gratings on request. Send dimensions and installation details to gitterroste@fenau.eu.